AMARRA
Voilier·Autre zone · New Bern

Morgan 382 · 1978

42 000 US$
Année
1978
Longueur
11,68 m
Heures moteur
1 300 h

Caractéristiques

Dimensions
Longueur
11,68 m
Largeur
3,66 m
Tirant d'eau
1,68 m
Construction
Type
Voilier
Chantier / marque
Morgan
Modèle
382
Année
1978
Matériau de la coque
Polyester / fibre de verre
État
Occasion
Documents et autres
Zone
Autre zone
Port d'attache
New Bern

Description

Ubicación: New Bern, North Carolina, Estados Unidos A teardrop-shaped hull, wide beam, discreet reverse transom, and long overhangs might be the hallmarks of a vintage racing boat, but Ted Brewer designed the Morgan 382 as a cruiser, not as a racer that could also be cruised. From 1977 to 1986, Morgan Yachts and its successor, Cat-alina-Morgan, built nearly 500 of the Morgan 382 and its later configurations, the 383 and 384. Owners have taken them everywhere. Visually, the boat is balanced and well proportioned, and the low cabin trunk and 6-inch bulwarks help keep the profile trim. At upward of 17,000 pounds on a waterline of 30 feet 6 inches, the boat is almost in the heavy-displacement category. The hull, however, with its elongated fin keel, skeg-attached rudder, and roundish bilge, isn’t that of a slow cruiser. The all-wood interior offers volumes of room and storage. The head of the double quarter berth to starboard serves as the seat for the nav area; opposite is a large and efficient galley. In the saloon, the L-shaped seat to port only seats two comfortably at the drop-leaf table. A wide settee and a narrow pilot berth occupy the starboard side. The head is roomy and has a fully enclosed shower, but because of the boat’s fine entry, the V-berth is relatively small. DETAILS Diesel motor, Perkins 4.108, rebuilt with only 1300 hours run time. Autopilot Ray Marine EV 200 less than five years old. Autopilot rudder post mount installed with Edson brass Rudder post clamp mechanism custom bore $650 value new. Hydraulic auto pilot control arm installed with feedback sensor and computer with compass navigation. Main sail very crisp, 160 genoa not so crisp. Full bottom job restoration completed in 2020 with Trinidad Top side of hull paint completed 2022 with easy epoxy by Petitt. Six New port glass installed 2021. Galley glass needs to be replaced. New raw water pump installed last year. New Rule bilge pump installed 2023. Rudder post repacked 2023. Prop shaft stuffing box repacked 2022. Fuel system completely flushed and tank pumped out and scrubbed in 2022. Standing rigging replaced and upsized in 2010 and is in excellent condition. Ground tackle upsized in 2020 with Delta 44 anchor and is in good condition. Call today and begin your plans to sail away! Barco en venta a través de Engel & Völkers Yachting. Ficha original: https://evyachtsales.com/yacht-details/?vessel=2825415
Description fournie par le vendeurAfficher la version anglaise

Version anglaise (traduction automatique)

Location: New Bern, North Carolina, United States A teardrop-shaped hull, wide beam, discreet reverse transom, and long overhangs might be the hallmarks of a vintage racing boat, but Ted Brewer designed the Morgan 382 as a cruiser, not as a racer that could also be cruised. From 1977 to 1986, Morgan Yachts and its successor, Cat-alina-Morgan, built nearly 500 of the Morgan 382 and its later configurations, the 383 and 384. Owners have taken them everywhere. Visually, the boat is balanced and well proportioned, and the low cabin trunk and 6-inch bulwarks help keep the profile trim. At upward of 17,000 pounds on a waterline of 30 feet 6 inches, the boat is almost in the heavy-displacement category. The hull, however, with its elongated fin keel, skeg-attached rudder, and roundish bilge, isn’t that of a slow cruiser. The all-wood interior offers volumes of room and storage. The head of the double quarter berth to starboard serves as the seat for the nav area; opposite is a large and efficient galley. In the saloon, the L-shaped seat to port only seats two comfortably at the drop-leaf table. A wide settee and a narrow pilot berth occupy the starboard side. The head is roomy and has a fully enclosed shower, but because of the boat’s fine entry, the V-berth is relatively small. DETAILS Diesel motor, Perkins 4.108, rebuilt with only 1300 hours run time. Autopilot Ray Marine EV 200 less than five years old. Autopilot rudder post mount installed with Edson brass Rudder post clamp mechanism custom bore $650 value new. Hydraulic auto pilot control arm installed with feedback sensor and computer with compass navigation. Main sail very crisp, 160 genoa not so crisp. Full bottom job restoration completed in 2020 with Trinidad Top side of hull paint completed 2022 with easy epoxy by Petitt. Six New port glass installed 2021. Galley glass needs to be replaced. New raw water pump installed last year. New Rule bilge pump installed 2023. Rudder post repacked 2023. Prop shaft stuffing box repacked 2022. Fuel system completely flushed and tank pumped out and scrubbed in 2022. Standing rigging replaced and upsized in 2010 and is in excellent condition. Ground tackle upsized in 2020 with Delta 44 anchor and is in good condition. Call today and begin your plans to sail away! Boat for sale through Engel & Völkers Yachting. Original listing: https://evyachtsales.com/yacht-details/?vessel=2825415

Moteur et propulsion

Moteur
Perkins 4-108 50 HP
Heures moteur
1 300 h
Carburant
Diesel

Estimez votre mensualité

Mensualité estimée
USD 326
Apport: USD 12 600
Montant financé: USD 29 400
Total remboursé (10 ans): USD 39 168

Calcul indicatif uniquement. Ce n'est pas une offre de financement ; les conditions réelles dépendent de chaque organisme.

Contacter le vendeur

Écrivez directement au vendeur sur WhatsApp ou par e-mail, ou envoyez votre demande d'ici.

Que souhaitez-vous faire ?

Votre message est transmis au vendeur. Nous n'utilisons vos données que pour cette demande. Confidentialité.

Plus de voiliers – Autre zone

Tout voir →
Morgan 382 · 1978
42 000 US$
WhatsApp